iglide® P210, sleeve bearing with flange, mm

iglide® P210 | Good coefficients of friction and wear on almost every shaft
PFAS-tested: All iglide materials labeled as "PFAS-tested" were tested for the 96 PFAS substances considered critical for the environment and health using the SQP M1227 test method (LC-MS/MS and GC-MS) and do not contain any substances >0.1% by mass. This category excludes substances from the group of fluoropolymers.

• Very little humidity absorption
• Extremely wear resistant especially up to 2900 psi in pivoting applications
• Versatile: good performance with many different shafts
• Good with edge loads
• Self-lubricating and maintenance-free
• Standard range from stock

iglide® P210 plain bearings provide the user with versatile all-round bearings, which have proven to have above average service life, primarily in pivoting applications at medium loads of up to 2900 psi. This versatile material has already proven its worth in many customer-specific solutions and as a bar stock material. Clip-on or pretensioned design as well as vehicle interior applications are possible.
 

When to use it? When you need a universal bearing for use in a moist environment When you need a wear-resistant bearing for pivoting applications at medium loads When edge loads and shocks occur When the surface pressure of iglide® J is insufficient

When not to use? When you need a universal bearing with the largest possible range of dimensions When you need a bearing for highly loaded pivoting applications If temperatures are higher than +212 °F

Tolerances and measurement system
The installation dimensions and tolerances of the iglide® plain bearings are a function of the material and wall thicknesses. For each material, the moisture absorption and the thermal expansion are imperative. Plain bearings with low moisture absorption can be designed with a minimal amount of tolerance. For wall thickness, the rule is: The thicker the bearings are, the larger the tolerances must be.
 
Assembly
iglide® bearings are press-fit bearings. The inner diameter adjusts only after press-fit in the proper housing bore with a recommended tolerance. The before press-fit oversized dimension can be up to 2% of the inner diameter. In this manner, the secure press-fitting of the bearing is achieved. Axial or radial shifts in the housing are also prevented.