iglide® H370, sleeve bearing, mm

iglide® H370 | Extremely long service life under water and high media-resistance

PFAS-tested: All iglide materials labeled as "PFAS-tested" were tested for 96 PFAS substances considered critical for the environment and health. This category excludes substances from the group of fluoropolymers.

• Wear-resistant – especially under water
• High temperature resistance –104 °F to +392 °F
• High chemical resistance
• Dry-running and maintenance-free
• Standard range from stock

iglide® H370 is the right solution for underwater applications. The bearings absorb extremely high loads, resist to chemicals and can be used at temperatures up to +392 °F.
 

When to use it? For underwater use When it is dependent on high temperature resistance When high mechanical loading and wear resistance is required When good resistance to chemicals is required

When not to use? When mechanical reaming of the wall surface is necessary When high wear resistance in temperatures is required For use in dirty surroundings When a cost-effective, large-volume solution is required

Tolerances and measurement system
The installation dimensions and tolerances of the iglide® plain bearings are a function of the material and wall thicknesses. For each material, the moisture absorption and the thermal expansion are imperative. Plain bearings with low moisture absorption can be designed with a minimal amount of tolerance. For wall thickness, the rule is: the thicker the bearings are, the larger the tolerances must be.
 
Assembly
iglide® bearings are press-fit bearings. The inner diameter adjusts only after press-fit in the proper housing bore with a recommended tolerance. The before press-fit oversized dimension can be up to 2% of the inner diameter. In this manner, the secure press-fitting of the bearing is achieved. Axial or radial shifts in the housing are also prevented.